This Smart Sensor kit replaces the tire pressure sensors on a 2017-2019 Cadillac XTS. The sensors are pre-programmed for the XTS's 315 MHz GM system, so they can be mounted and learned to the car without a separate programming step.
The XTS is a big, heavy sedan, and many of them spent their lives in livery and executive car service where they piled up miles quickly. Sensors on these cars wear out from age and mileage, and a dead sensor battery means the whole sensor has to be replaced. These Smart One sensors go in the factory location and report pressure to the XTS's driver information center just like the originals.
The sensors are built to SAE J1205 and J1206 test standards for temperature extremes and corrosion. Installation requires the tire to be removed from the wheel.
Relearn on the XTS
The XTS uses GM's standard relearn. Start learn mode from the driver information center, or press and hold the lock and unlock buttons on the key fob until the horn chirps twice. Then wake each sensor with a TPMS tool in order: left front, right front, right rear, left rear. The horn chirps as each one is learned. A scan tool can also run the relearn through the diagnostic port.
Common questions
Will these fit an earlier XTS? The XTS used the same 315 MHz system through its whole 2013-2019 run, but this kit is listed for 2017-2019. If you have an earlier car, put your VIN in the order notes and we will confirm.
Can I do the relearn myself? Yes, with an inexpensive TPMS activation tool. Without one, any tire shop can do it in a few minutes.