2015-2020 Jeep Wrangler Pre-Programmed Smart TPMS Tire Pressure Sensors Kit

This Smart Sensor kit replaces the tire pressure sensors on 2015-2020 Jeep Wranglers, covering the late JK and the early JL. Both generations use the same 433 MHz Mopar sensor in this range, and these come pre-programmed for it, so they go straight into the wheels.

Wranglers go through TPMS sensors faster than most vehicles. Owners swap wheels and tires for bigger sizes, run a second set for the trail, and break sensors on rocks or during tire changes. Each new set of wheels needs its own sensors if you want the dash to keep showing pressures instead of a warning light. These Smart One sensors replace the factory parts in the stock location and report to the Wrangler's cluster the same way.

The sensors are tested to SAE J1205 and J1206 standards for temperature extremes and corrosion, which matters on a Jeep that sees mud, salt and water crossings. The tire has to come off the wheel to install them.

Relearn on the Wrangler

The JK and JL learn new sensors automatically. After the sensors are installed, let the Jeep sit for about 15 to 20 minutes, then drive above about 15 mph for up to 20 minutes and the pressures will show up in the cluster. No scan tool is needed.

Know your build date

JL Wranglers built after mid 2021 moved to a different sensor, which is outside this kit's 2015-2020 range. If you have a JL and are not sure of the build date, check the sticker in the driver door jamb.

Common questions

Will these work with my aftermarket wheels? Yes, as long as the wheel has a standard valve stem hole. Most aftermarket Jeep wheels are drilled for TPMS.

Will these work on a 2018 JK and a 2018 JL? Yes. Both use the same 433 MHz sensor in 2018.

Fitment: 2015, 2016, 2017, 2018 Jeep Wrangler JK and 2018, 2019, 2020 Jeep Wrangler JL