This Smart Sensor kit replaces the tire pressure sensors on a 2009-2013 Buick LaCrosse. The sensors are pre-programmed for the LaCrosse's 315 MHz GM system, so the tire shop can mount them and go straight to the relearn.
The factory sensors on these cars are now well over ten years old, and their sealed batteries are the most common reason a LaCrosse shows a TPMS warning or a dash on one of the tire pressure readouts. Once the battery is gone the sensor has to be replaced, and a dealer set can cost far more than an aftermarket kit. These Smart One sensors install in the factory location and report to the LaCrosse's driver information center the same way the originals did.
They meet SAE J1205 and J1206 test standards for heat, cold and corrosion. The tire has to be off the wheel to install them.
Relearn on the LaCrosse
The LaCrosse uses GM's standard relearn. With the ignition on, use the driver information center to start the tire learn mode, or press the SET/CLR button on the tire pressure screen. Then wake each sensor with a TPMS tool in order, left front, right front, right rear and left rear. The horn chirps as each sensor is learned and double chirps when all four are done.
2009 models
The 2009 LaCrosse was the last year of the previous generation and used a different factory sensor than the 2010-2013 cars. If you have a 2009, put your VIN in the order notes and we will confirm fitment before it ships.
Common questions
Why do the pressures show dashes instead of numbers? That usually means the car is not hearing from a sensor, most often because its battery is dead.
Can I do the relearn at home? Yes, if you have a TPMS activation tool. Without one, any tire shop can do it in a few minutes.