Corvette America 58635 Right Hand Chrome Replacement Front Bumper For 1963-1967 Chevrolet Corvette Base

Corvette America Is Proud To Introduce Their Very First Replacement Bumpers For C2 Corvettes. These Quality Bumpers Feature A Beautiful Chrome Finish And High Quality Steel Construction. Every Effort Has Been Made To Replicate The OEM Design And Bracket Positioning, However Fitting May Be Required To Achieve Desired Fit To Your Specific Car. With Any Bumper, It Is Highly Recommended To Test Fit Prior To Completing Any Finishing Work On The Body. Holes In The Fiberglass Were Set By Using The Original Bumper As An Index, So Variances In Their Production Lead To Slight Variances In Hole Placement(s) On The Body During Production Cycles. Click On The "Instructions" Tab To See An Original AIM Sheet For Further Information.

C2 Front Bumper Installation Tips As Shared By Our Installers; 1) Begin Installation With The Front Inner Brackets Which Protrude From Below The Bumper Cover; 2) Slight Adjustments Of The Brackets May Be Necessary; 3) Only Install Each Bolt By A Few Threads So You Can Adjust The Fitment Before Final Tightening; 4) Remember To Install The Center Bar Before Tightening Any Hardware; 5) Tighten Hardware From The Center Of The Vehicle Outwards, With The Center Bar Being *Last*. Start At The Front Inner Brackets, Then Front Outer Brackets, Then Front Outer Bolt(s) Through Fiberglass, And Lastly The Center Bar.; Reference Attached Instruction Sheets for Torque Values

Steel

Chrome

Fitment: 1963, 1964, 1965, 1966, 1967 Chevrolet Corvette Base